LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical (Qr25DE)) >> Service Information >> Noise, Vibration And Harshness (NVH) Troubleshooting >> Use the Chart Below to Help You Find the Cause of the Symptom

Use the Chart Below to Help You Find the Cause of the Symptom

WARNING: This page is about a different variant/trim than selected.
  1. Locate the area where noise occurs.
  2. Confirm the type of noise.
  3. Specify the operating condition of engine.
  4. Check specified noise source.

    If necessary, repair or replace these parts.

    TROUBLESHOOTING CHART

    Location of noise Type of noise Operating condition of engine Source of noise Check item Reference Information
    Before warm-up After warm-up When starting When idling When racing While driving
    Top of engine Rocker cover Cylinder head Ticking or clicking C A - A B - Tappet noise Valve clearance VALVE CLEARANCE 
    Rattle C A - A B C Camshaft bearing noise Camshaft journal clearance
    Camshaft runout
    CAMSHAFT 
    CAMSHAFT 
    Crankshaft pulley Cylinder block (Side of engine) Oil pan Slap or knock - A - B B - Piston pin noise Piston and piston pin clearance
    Connecting rod bushing clearance
    PISTON AND PISTON PIN CLEARANCE 
    CONNECTING ROD BUSHING OIL CLEARANCE (SMALL END) 
    Slap or rap A - - B B A Piston slap noise Piston-to-bore clearance
    Piston ring side clearance
    Piston ring end gap
    Connecting rod bend and torsion
    PISTON TO CYLINDER BORE CLEARANCE 
    PISTON RING SIDE CLEARANCE 
    PISTON RING END GAP 
    CONNECTING ROD BEND AND TORSION 
    Knock A B C B B B Connecting rod bearing noise Connecting rod bushing clearance (Small end)
    Connecting rod bearing clearance (Big end)
    CONNECTING ROD BUSHING OIL CLEARANCE (SMALL END) 
    CONNECTING ROD BEARING (BIG END) 
    Knock A B - A B C Main bearing noise Main bearing oil clearance
    Crankshaft runout
    MAIN BEARING 
    CRANKSHAFT RUNOUT 
    Front of engine Timing chain cover Tapping or ticking A A - B B B Timing chain and chain tensioner noise Timing chain cracks and wear
    Timing chain tensioner operation
    TIMING CHAIN 
    Front of engine Squeaking or fizzing A B - B - B Drive belts (Sticking or slipping) Drive belts deflection DRIVE BELTS 
    Creaking A B A B A B Drive belts (Slipping) Idler pulley bearing operation
    Squall Creak A B - B A B Water pump noise Water pump operation COOLING SYSTEM
    A: Closely related B: Related C: Sometimes related -: Not related