Removal and Installation: Installation
WARNING: This page is about a different variant/trim than selected.
Installation is in the reverse order of removal. Pay attention to the following.
Tightening Exhaust Manifold Nuts
- Tighten the nuts in the numerical order shown in the figure, to specification.
Installation of A/F Sensors and Heated Oxygen Sensors
Clean the A/F sensor and heated oxygen sensor threads with the Tool, then apply the anti-seize lubricant to the threads before installing the A/F sensor and heated oxygen sensors.
Oxygen sensor thread cleaner : J-43897 - 18
Oxygen sensor thread cleaner : J-43897 - 12
CAUTION:
Do not over-tighten the A/F sensors and heated oxygen sensors. Doing so may cause damage to the A/F sensors and heated oxygen sensors, resulting in a malfunction and the MIL coming on.