LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical (Qr25DE)) >> Service Information >> Drive Belts >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the splash shield (RH). Refer to "COMPONENT ".
  2. Securely hold the hexagonal part in pulley center of drive belt auto-tensioner, move in the direction of arrow (loosening direction of tensioner) using Tool.

    Tool number : - (J-46535) 

    Fig 1: Loosening Direction Of Tensioner Using Tool
    G07137418Courtesy of NISSAN MOTOR CO., U.S.A.
    WARNING: Never place hand in a location where pinching may occur if the holding tool accidentally comes off.
    CAUTION: Do not loosen the auto-tensioner pulley bolt. (Do not turn it counterclockwise.) If turned counterclockwise, the complete auto-tensioner must be replaced as a unit, including pulley.
  3. Insert a rod approximately 6 mm (0.24 in) in diameter through the rear of tensioner into retaining boss to lock tensioner pulley.
    • Leave tensioner pulley arm locked until belt is installed again.
  4. Remove drive belt.
scientia non olet · About LEMON Manuals