LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical (Qr25DE)) >> Service Information >> Drive Belts >> Removal and Installation of Drive Belt Auto-tensioner >> Removal

Removal and Installation of Drive Belt Auto-tensioner: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: The complete auto-tensioner must be replaced as a unit, including the pulley.
  1. Remove the RH front wheel and tire. Refer to "ADJUSTMENT ".
  2. Remove the drive belt "REMOVAL AND INSTALLATION ".
  3. Remove the engine room cover.
  4. Remove the engine coolant reservoir.
  5. Support the engine and remove the engine mounting insulator and bracket (RH). Refer to "REMOVAL AND INSTALLATION ".
  6. Remove the drive belt auto-tensioner.
    CAUTION: Do not loosen the auto-tensioner pulley bolt. (Do not turn it counterclockwise). If turned counterclockwise, the complete auto-tensioner must be replaced as a unit, including pulley.
scientia non olet · About LEMON Manuals