LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical (Qr25DE)) >> Service Information >> Cylinder Head >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the timing chain. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the camshafts. Refer to CAMSHAFT .
  3. Remove spark plugs. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove exhaust manifold. Refer to "REMOVAL AND INSTALLATION ".
  5. Remove cylinder head loosening bolts in the order as shown in the figure below, using power tool.
  6. Remove water outlet, if necessary. Refer to "COMPONENT ".
    Fig 1: Cylinder Head Bolt Loosening Sequence
    G07137532Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals