Outer Diameter Of Lower Cylinder Block Bolt

WARNING: This page is about a different variant/trim than selected.

Perform only with M10 (0.39 in) bolts.
Measure outer diameters (d1, d2) at two positions as shown in the figure.
Measure d2 at a point within area A as shown in the figure.
When the value of d1-d2 exceeds the limit (a large difference in dimensions), replace the bolt with a new one.
Limit : 0.13 mm (0.0051 in)

Fig 1: Checking Outer Diameter Of Lower Cylinder Block Bolt
Courtesy of NISSAN MOTOR CO., U.S.A.