LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical (Qr25DE)) >> Service Information >> Air Cleaner And Air Duct >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery tray. Refer to "REMOVAL AND INSTALLATION (QR25DE BATTERY TRAY) ".
  2. Remove the engine room cover.
  3. Disconnect the mass air flow sensor electrical connector.
  4. Disconnect the tube clamp at the electric throttle control actuator and the fresh air intake tube.
  5. Remove air cleaner to electric throttle control actuator tube, air cleaner case, with mass air flow sensor attached.
    • Add marks as necessary for easier installation.
  6. Remove mass air flow sensor from air cleaner case, as necessary.
    CAUTION: Handle the mass air flow sensor with care:
    • Do not shock it.
    • Do not disassemble it.
    • Do not touch the internal sensor.
  7. Remove the resonator in the fender, if necessary.
    1. Remove the left front wheel and tire. Refer to "ADJUSTMENT ".
    2. Partially remove the left front fender protector. Refer to "REMOVAL AND INSTALLATION ".
    3. Remove the left hand side splash shield. Refer to "REMOVAL AND INSTALLATION ".
    4. Remove the engine under cover. Refer to "REMOVAL AND INSTALLATION ".
scientia non olet · About LEMON Manuals