Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Installation is in the reverse order of removal.

If transaxle is removed from the vehicle, always replace CSC. Refer to "REMOVAL AND INSTALLATION ".
When installing the transaxle assembly to the engine, install the bolts as shown in the figure.
CAUTION: When installing transaxle assembly, be careful not to bring transaxle input shaft into contact with clutch cover.

Fig 1: View Of Transaxle Assembly Bolts Tightening Sequence
Courtesy of NISSAN MOTOR CO., U.S.A.

BOLTS SPECIFICATIONS

Bolt No.	1	2
Quantity	3	6
Bolt length "l " mm (in)	60 (2.36)	50 (1.97)
Tightening torque N.m (kg-m, ft-lb)	62.0 (6.3, 46)

A: M/T to engine
B: Engine to M/T

Bleed the air from the clutch hydraulic system. Refer to "AIR BLEEDING PROCEDURE ".
After installation, check oil level, and check for leaks and loose mechanisms. Refer to "CHECKING M/T OIL ".