Disassembly and Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove snap ring (1).

Fig 1: Removing Snap Ring
Courtesy of NISSAN MOTOR CO., U.S.A.
Install Tool (A) and suitable tool onto 6th main gear (1), and remove mainshaft rear bearing inner race (2) and 6th main gear (1) from mainshaft.
Tool number A: ST33052000 (-)

Fig 2: Removing Mainshaft Rear Bearing Inner Race And 6th Main Gear From Mainshaft
Courtesy of NISSAN MOTOR CO., U.S.A.
Install Tool (A) and suitable tool onto 4th main gear (1), and remove 5th main gear (2), and 4th main gear (1) from mainshaft.
Tool number A: ST33052000 (-)

Fig 3: Removing 5th Main Gear, And 4th Main Gear From Mainshaft
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove intermediate adjusting shim.
Install Tool (A) and suitable tool onto 1st main gear (1), and remove 1st main gear (1), 1st-2nd synchronizer assembly (2), 2nd main gear (3), bushing, and 3rd main gear (4) from mainshaft.
Tool number A: ST33052000 (-)

Fig 4: Removing 1st Main Gear, 1st-2nd Synchronizer Assembly, 2nd Main Gear, Bushing, And 3rd Main Gear
Courtesy of NISSAN MOTOR CO., U.S.A.
Install Tool (A) and suitable tool onto mainshaft front bearing inner race (1), and remove mainshaft front bearing inner race (1) from mainshaft.
Tool number A: ST33052000 (-)

Fig 5: Removing Mainshaft Front Bearing Inner Race From Mainshaft
Courtesy of NISSAN MOTOR CO., U.S.A.