Disassembly and Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

Note the following. Assembly is in the reverse order of disassembly. Refer to "DISASSEMBLY AND ASSEMBLY ".

Press-fit the input shaft front bearing (1) onto the input shaft using a suitable tool (A).

Fig 1: Pressing-Fit Input Shaft Front Bearing Onto Input Shaft Using Suitable Tool
Courtesy of NISSAN MOTOR CO., U.S.A.
Press-fit the input shaft rear bearing (1) onto the input shaft using a suitable tool (A), and Tool (B).
Tool number B: ST36720030 (-)
CAUTION:
- Do not reuse snap ring.
- Make sure that snap ring is securely installed in the groove.
  
  Fig 2: Pressing-Fit Input Shaft Rear Bearing Onto Input Shaft Using Suitable Tool
  Courtesy of NISSAN MOTOR CO., U.S.A.
- Be careful with the orientation of 3rd-4th synchronizer hub.
  1. A: 3rd input gear side
  2. B: 4th input gear side
    
    Fig 3: Identifying 3rd-4th Synchronizer Hub
    Courtesy of NISSAN MOTOR CO., U.S.A.
- Be careful with the orientation of 5th-6th synchronizer hub.
  1. A: 5th input gear side
  2. B: 6th input gear side
    
    Fig 4: Identifying 5th-6th Synchronizer Hub
    Courtesy of NISSAN MOTOR CO., U.S.A.