LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Clutch) >> Service Information >> Clutch Piping >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery. Refer to "REMOVAL AND INSTALLATION (MR20DE BATTERY) " or "REMOVAL AND INSTALLATION (QR25DE BATTERY) ".
  2. Remove the air cleaner and air duct. Refer to "REMOVAL AND INSTALLATION " (MR20DE) or "REMOVAL AND INSTALLATION " (QR25DE).
  3. Remove clutch tube lock pin from clutch master cylinder, if necessary.
  4. Remove clutch tube lock pin at clutch housing, if necessary.
  5. Remove clutch tube lock pins (2) from clutch damper (3).
  6. Remove clutch tubes (1) from clutch damper (3).
  7. Remove clutch damper (3) from bracket (4).
    Fig 1: Identifying Clutch Tubes, Clutch Tube Lock Pins, Clutch Damper And Bracket
    G04926340Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals