LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Clutch) >> Service Information >> Clutch Pedal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove instrument panel lower finisher. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove front upper floor duct. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect ASCD clutch switch harness connector (if equipped).
  4. Disconnect master cylinder rod end from clutch pedal lever.
  5. Remove clutch pedal assembly nuts, and then remove clutch pedal assembly.
  6. Disconnect clutch interlock switch harness connector.
    Fig 1: Location Of ASCD Switch
    G04888793Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals