LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Clutch) >> Service Information >> Clutch Master Cylinder >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Tilt master cylinder clockwise by 45° and insert it in the mounting hole. Rotate counterclockwise to secure it. At this time, nipple is in the up position.
  2. Install master cylinder rod end to clutch pedal.
    Fig 1: Identifying Master Cylinder, Master Cylinder Mounting Hole And Master Cylinder Tilting Angle
    G04888804Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Install clutch tube (1) fully into connector of master cylinder (2).
  4. Install lock pin (3) fully into connector of master cylinder (2).
  5. Fill with new clutch fluid and bleed air from the system. Refer to "AIR BLEEDING PROCEDURE ".
  6. After completing this procedure, inspect clutch pedal operation. Refer to "ON-VEHICLE INSPECTION AND ADJUSTMENT ".
  7. Install the air cleaner and air duct. Refer to "REMOVAL AND INSTALLATION " (MR20DE) or "REMOVAL AND INSTALLATION " (QR25DE).
  8. Install the battery and battery tray. Refer to "REMOVAL AND INSTALLATION (MR20DE BATTERY) " or "EXPLODED VIEW (QR25DE BATTERY TRAY) ".
  9. Install the engine room cover.
  10. Install the engine under cover. Refer to "REMOVAL AND INSTALLATION ".
    Fig 2: Installing Lock Pin Into Connector Of Master Cylinder
    G04888805Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals