Front Wiper Does Not Stop

CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT-III
1. Select "BCM" on CONSULT-III, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR". Make sure that "FR WIPER INT", "FR WIPER LOW", "FR WIPER HI", and "FR WASHER SW" turn ON-OFF according to front wiper switch operation.
  Without CONSULT-III
  
  Refer to "COMBINATION SWITCH INSPECTION ".
  
  OK or NG
  
  OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".
  
  NG: Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".