LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Rogue S, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter, Warning Lamp & Indicator >> DTC/Circuit Diagnosis >> Power Supply And Ground Circuit >> Combination Meter >> COMBINATION METER : Diagnosis Procedure

COMBINATION METER : Diagnosis Procedure

  1. CHECK FUSE

    Check for blown fuses.

    FUSE REFERENCE CHART

    Terminal No. Signal name Fuses No.
    1 Battery power supply 9
    2 Ignition signal 3

    Is the inspection result normal? 

    YES: Go to 2.

    NO: Be sure to eliminate cause of malfunction before installing new fuse.

  2. CHECK POWER SUPPLY CIRCUIT

    Check voltage between combination meter harness connector and ground.

    TERMINAL VOLTAGE REFERENCE CHART

    Terminals Ignition switch position
    (+) (-)
    Combination meter OFF ON
    Connector Terminal
    M34 1 Ground Battery voltage Battery voltage
    2 Approx. 0 V Battery voltage

    Is the inspection result normal? 

    YES: Go to 3.

    NO: Check harness between combination meter and fuse.

  3. CHECK GROUND CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect combination meter connector.
    3. Check continuity between combination meter harness connector and ground.
      TERMINAL CONTINUITY REFERENCE CHART

      Combination meter Ground Continuity
      Connector Terminal
      M34 3 Existed
      4

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Repair harness or connector.

scientia non olet · About LEMON Manuals