Diagnosis Procedure

1. Turn ignition switch ON.
2. Check voltage between combination meter harness connector and ground.
   TERMINAL VOLTAGE REFERENCE CHART
   
   

   Terminals			Voltage (Approx.)
   (+)		(-)
   Combination meter		Ground
   Connector	Terminal
   M34	34		Courtesy of NISSAN MOTOR CO., U.S.A.

   Does it match fuel gauge reading? 

   YES: Replace the combination meter. Refer to "REMOVAL AND INSTALLATION ".

   NO: Go to 2.

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and fuel level sensor unit (main) connector.
3. Check continuity between combination meter harness connector and fuel level sensor unit (main) harness connector.
   TERMINAL CONTINUITY REFERENCE CHART
   
   

   Combination meter		Fuel level sensor unit (main)		Continuity
   Connector	Terminal	Connector	Terminal
   M34	34	B40	4	Existed

4. Check continuity between combination meter harness connector and ground.
   TERMINAL CONTINUITY REFERENCE CHART
   
   

   Combination meter		Ground	Continuity
   Connector	Terminal
   M34	34		Not existed

   Is the inspection result normal? 

   YES: Go to 3.

   NO: Repair harness or connector.

Check continuity between fuel level sensor unit (main) harness connector and combination meter harness connector.

Is the inspection result normal? 

YES: INSPECTION END

NO: Repair harness or connector.