Disassembly and Assembly

Disassembly

1. Remove console rear finisher assembly.
   1. Console rear finisher assembly (1) fixing clips and pawls using a remover tool.
   2. Pull back console rear finisher assembly.
      Fig 1: Location Of Console Rear Finisher Assembly

      Courtesy of NISSAN MOTOR CO., U.S.A.
2. Remove rear cup holder assembly.
   1. Remove rear cup holder assembly (1) fixing screws (A).
   2. Pull back rear cup holder assembly.
      Fig 2: Location Of Rear Cup Holder Assembly And Fixing Screws

      Courtesy of NISSAN MOTOR CO., U.S.A.
3. Remove console lid assembly.
   1. Remove console mask (1) fixing pawls with remover tool, and then remove console mask.
   2. Remove console lid assembly fixing screws (A).
   3. Pull up console lid assembly.
      Fig 3: Location Of Console Mask And Fixing Pawls

      Courtesy of NISSAN MOTOR CO., U.S.A.
4. Remove console upper finisher.
   1. Remove console upper finisher (1) fixing screws (A).
   2. Remove console upper finisher fixing clips with remover tool.
   3. Pull up console upper finisher.
   4. Disconnect harness connectors. (if equipped)
      Fig 4: Location Of Console Upper Finisher And Fixing Screws

      Courtesy of NISSAN MOTOR CO., U.S.A.
5. Remove inside key antenna. Refer to "CONSOLE : REMOVAL AND INSTALLATION ".
6. Remove power socket. Refer to "CONSOLE POWER SOCKET : REMOVAL AND INSTALLATION ".
7. Remove console harness assembly.

Assembly

Assemble in the reverse order of disassembly.