LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2010 >> Rogue SL, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter, Warning Lamp & Indicator >> Symptom Diagnosis >> The Oil Pressure Warning Lamp Does Not Turn Off >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK OIL PRESSURE WARNING LAMP

    Perform auto active test. Refer to "DIAGNOSIS DESCRIPTION ".

    Is oil pressure warning lamp illuminated? 

    YES: GO TO 2.

    NO: Replace combination meter.

  2. CHECK IPDM E/R OUTPUT VOLTAGE
    1. Turn ignition switch OFF.
    2. Disconnect the oil pressure switch connector.
    3. Turn ignition switch ON.
    4. Check voltage between the oil pressure switch harness connector terminal and ground.
    CONNECTOR TERMINAL VOLTAGE CHART

    Terminal Voltage (Approx.)
    (+) (-)
    Oil pressure switch
    Connector Terminal
    F63 1 Ground 12 V

    Is the inspection result normal? 

    YES: GO TO 3.

    NO: GO TO  4.

  3. CHECK OIL PRESSURE SWITCH

    Check the oil pressure switch. Refer to , "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".

    NO: Replace oil pressure switch.

  4. CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT

    Check the oil pressure switch signal circuit. Refer to , "DIAGNOSIS PROCEDURE ".

    Is the inspection result normal? 

    YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".

    NO: Repair harness or connector.

scientia non olet · About LEMON Manuals