Front Wiper Intermittent Operation Switch Position Cannot Be Adjusted

With CONSULT-III 

1. Select "BCM" on CONSULT-III, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR". Make sure that "INT VOLUME", changes in order from 1 to 7 according to wiper switch operation.

Without CONSULT-III 

Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG 

OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".

NG: Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".

Wiper Does Not Wipe When Front Washer Operates

1. CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM

   With CONSULT-III 

   1. Select "BCM" on CONSULT-III, and select "WIPER" on "SELECT TEST ITEM" screen.
   2. Select "DATA MONITOR". Make sure that "FR WASHER SW" turn ON-OFF according to front wiper switch operation.

   Without CONSULT-III 

   Refer to "COMBINATION SWITCH INSPECTION ".

   OK or NG 

   OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".

   NG: Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".