LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System >> Service Information >> Rear Drum Brake >> Disassembly and Assembly of Wheel Cylinder >> Assembly

Disassembly and Assembly of Wheel Cylinder: Assembly

CAUTION: Do not use NISSAN rubber grease (KRE00 00010, KRE00 00011) during assembly.
  1. Install the bleed valve and cap, tighten to specification. Refer to "COMPONENT ".
  2. Apply brake fluid to the piston sliding surface on the wheel cylinder.
  3. Apply NISSAN rubber lubricant (KRE12 00030) to the piston cups and boots. Assemble the spring, piston cups, and piston inside the wheel cylinder as shown.
    CAUTION: When inserting the piston, be careful not to scratch the wheel cylinder wall.
    Fig 1: Applying Lubricant To Piston Cups And Boots
    G05924532Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Install the boots on the wheel cylinder securing them in the grooves as shown.
  5. Install the wheel cylinder. Refer to "REMOVAL AND INSTALLATION OF WHEEL CYLINDER ".
scientia non olet · About LEMON Manuals