LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System >> Service Information >> Brake Tube And Hose >> Rear Brake Tube and Hose >> Rear Brake Hose - Qr25DE >> Removal

Rear Brake Hose - Qr25DE: Removal

CAUTION:
  • Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately.
  • Cover the open end of brake tubes and hoses when disconnecting to prevent entrance of dirt.
  1. Drain the brake fluid. Refer to "DRAIN AND REFILL ".
  2. Disconnect the brake hose from brake tube, using a flare nut wrench and then remove the lock plate.
    Fig 1: Identifying Brake Tube To Brake Hose And Flare Nut
    G04899239Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove the union bolt (A), and then remove brake hose from brake caliper assembly and discard the copper washers.
    CAUTION: Do not reuse the copper washers.
    Fig 2: Identifying Brake Hose Union Bolt
    G05871211Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove the brake hose.
scientia non olet · About LEMON Manuals