Parking, License Plate and Tail Lamps Do Not Illuminate

Inspect tail lamp 10A fuses (No. 36 and 37, located in IPDM E/R).

OK or NG 

OK: GO TO 2.

NG: Repair harness.

With CONSULT-III

1. Select "BCM" on CONSULT-III. Select "HEAD LAMP" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR". Make sure "LIGHT SW 1ST" turns ON-OFF linked with operation of lighting switch.

   When lighting switch is 1ST position : LIGHT SW 1ST ON 

Without CONSULT-III

Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG 

OK: GO TO 3.

NG: Check combination switch (lighting switch). Refer to "COMBINATION SWITCH INSPECTION ".

With CONSULT-III

1. Select "IPDM E/R" on CONSULT-III, and select "ACTIVE TEST".
2. Select "TAIL LAMP" on "SELECT TEST ITEM" screen.
3. Touch "ON" on "ACTIVE TEST" screen.
4. Make sure parking, license plate and tail lamps operate.

   Parking, license plate and tail lamps should operate. 

Without CONSULT-III

1. Start auto active test. Refer to "AUTO ACTIVE TEST ".
2. Make sure parking, license plate and tail lamps operate.

   Parking, license plate and tail lamps should operate. 

OK or NG 

OK: GO TO 4.

NG: Replace the IPDM E/R if the parking, license and tail lamps do not start operating after resetting connector. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

1. Select "IPDM E/R" on CONSULT-III, and select "DATA MONITOR".
2. Make sure "TAIL&CLR REQ" turns ON when lighting switch is in 1ST position.

   When lighting switch is 1ST position : TAIL&CLR REQ ON 

OK or NG 

OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".