Front Parking Lamps Do Not Illuminate (License Plate and Tail Lamps Operate Normally)

Inspect parking lamp 10A fuse (No. 37, located in IPDM E/R)

OK or NG 

OK: GO TO 2.

NG: Repair harness.

With CONSULT-III

1. Turn ignition switch OFF.
2. Disconnect front combination lamp connectors.
3. Turn ignition switch ON.
4. Select "IPDM E/R" on CONSULT-III, and select "ACTIVE TEST".
5. Select "TAIL LAMP" on "SELECT TEST ITEM" screen.
6. Touch "ON" on "ACTIVE TEST" screen.
7. When tail lamp relay is operating, check voltage between front combination lamp and ground.

Without CONSULT-III

1. Turn ignition switch OFF.
2. Disconnect front combination lamp connectors.
3. Turn ignition switch ON.
4. Start auto active test. Refer to "AUTO ACTIVE TEST ".
5. When tail lamp relay is operating, check voltage between front combination lamp and ground.

Fig 1: Checking Voltage Between Front Combination Lamp And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO  4.

NG: GO TO 3.

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between IPDM E/R harness connector (A) and front combination lamp harness connector (B).

Fig 2: Checking Continuity Between IPDM E/R Connector And Front Combination Lamp Connector Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: Repair harness or connector.

Check continuity between front combination lamp harness connector and ground.

Fig 3: Checking Continuity Between Front Combination Lamp Connector Terminal 2 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Check bulbs.

NG: Repair harness or connector.