LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Transmission >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Transfer: TY20A >> Disassembly And Assembly >> Transfer Case >> Assembly

Transfer Case: Assembly

  1. Select the gear ring bearing adjusting shim (transfer case side). Refer to "ADJUSTMENT ".
  2. Install the selected gear ring bearing adjusting shim (transfer side) and gear ring bearing outer race (transfer side) to the transfer case with drifts.

    Apply gear oil to the drive pinion bearing (transfer side).

    CAUTION:
    • Never reuse drive pinion bearing (transfer side).
    Fig 1: Installing Selected Gear Ring Bearing Adjusting Shim
    G05892813Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Install the oil defense, and tighten the mounting bolts to the specified torque. Refer to "EXPLODED VIEW ". The clearance (A) between the oil defense and transfer case should be the following.

    Clearance between oil defense and transfer case 

    A : 1.0 - 3.5 mm (0.04 - 0.138 in) 

    CAUTION: Never reuse mounting bolts.
    Fig 2: Identifying Clearance Between Oil Defense And Transfer Case
    G04921301Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Install the transfer case oil seal until it becomes flush with the case end with drift (A) [SST: ST30720000 (J-25405)].
    CAUTION:
    • When checking the total preload torque, measure it without the oil seal, then install the oil seal.
    • Never reuse oil seal.
    • Apply multi-purpose grease onto oil seal lips, and gear oil onto the circumference of the oil seal.
    Fig 3: Installing Transfer Case Oil Seal
    G05892815Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Apply sealant to filler plug and plug before installing them to the transfer case. Refer to "EXPLODED VIEW ".

    Use Genuine Silicone RTV or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".

  6. Install breather tube to the transfer case.
    CAUTION: Never reuse breather tube.
  7. Install drive gear assembly. Refer to "ASSEMBLY ".
  8. Install adapter case. Refer to "ASSEMBLY ".
  9. Install drive pinion assembly. Refer to "ASSEMBLY ".
  10. Install air breather hose.
    CAUTION: Make sure there are no pinched or restricted areas on the breather hose caused by bending or winding when installing it.
    • Be sure to insert air breather hose into breather tube (metal connector) until hose end reaches the tube's base.
      Fig 4: Identifying Air Breather Hose Into Breather Tube
      G04875624Courtesy of NISSAN MOTOR CO., U.S.A.
    • Be sure to insert the hose till the paint mark.
    Fig 5: Inserting Hose Till Paint Mark
    G04921266Courtesy of NISSAN MOTOR CO., U.S.A.
  11. Check backlash, tooth contact, total preload and companion flange runout. Refer to "ADJUSTMENT ".
CAUTION: Measure the total preload without the adapter case oil seals.
scientia non olet · About LEMON Manuals