LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Transmission >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Transfer: TY20A >> Component Diagnosis >> C1210 ECM >> Diagnosis Procedure

Diagnosis Procedure

  1. PERFORM ECM SELF-DIAGNOSIS

    With CONSULT-III 

    Perform ECM self-diagnosis.

    Is any DTC detected? 

    YES: Check the DTC.

    NO: GO TO  2.

  2. PERFORM SELF-DIAGNOSIS

    With CONSULT-III 

    1. Erase AWD control unit self-diagnostic results.
    2. Turn the ignition switch OFF.
    3. Start the engine. Drive the vehicle for a while.
    4. Make sure that malfunction indicator lamp (MIL) turns OFF.
    5. Stop the vehicle. Perform AWD control unit self-diagnosis.

    Is DTC "C1210" detected? 

    YES: Replace AWD control unit. Refer to "EXPLODED VIEW ".

    NO: Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.

scientia non olet · About LEMON Manuals