Diagnosis Procedure
- PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS
With CONSULT-III
Perform ABS actuator and electric unit (control unit) self-diagnosis.
Is any DTC detected?
YES: Check the DTC.
NO: GO TO 2.
- PERFORM SELF-DIAGNOSIS
With CONSULT-III
- Erase AWD control unit self-diagnostic results.
- Start the engine and drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute.
- Make sure that ABS warning lamp turns OFF.
- Perform AWD control unit self-diagnosis.
Is DTC "C1203" detected?
YES: Replace AWD control unit. Refer to "EXPLODED VIEW ".
NO: Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.