LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Transfer: TY20A >> On-Vehicle Repair >> Side Oil Seal >> Removal and Installation >> Installation

Removal and Installation: Installation

  1. Apply multi-purpose grease to side oil seal lips. As shown in the figure, install side oil seal so that it becomes flush with the case end surface, using the drift (A) [SST: KV38101700 (-)].
    CAUTION:
    • Never reuse side oil seal.
    • Be careful not to incline side oil seal.
    Fig 1: Installing Side Oil Seal
    G05892763Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Install front drive shaft (right side). Refer to "EXPLODED VIEW ".
    CAUTION: Be careful not to damage gear ring oil seal inside of transfer.
  3. Check oil level and leakage. Refer to "INSPECTION ".
scientia non olet · About LEMON Manuals