LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Transfer: TY20A >> Function Diagnosis >> Diagnosis System (AWD Control Unit) >> CONSULT-III Function (ALL MODE AWD/4WD) >> Active Test

Active Test

Description 

Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control unit gives drive signal to actuator with receiving command from CONSULT-III to check operation of actuator.

Test Item 

MONITOR ITEM SPECIFICATION

Test item Condition Description
ETS S/V
(Detects AWD solenoid)
  • Vehicle stopped
  • Engine running
  • No DTC detected
 Change command current value to AWD solenoid, and then change driving mode. (Monitor value is normal if it is within approx. ±10% of command value.)
  • Qu: Increase current value in increments of 0.2 A
  • Qd: Decrease current value in increments of 0.2 A
  • UP: Increase current value in increments of 0.02 A
  • DOWN: Decrease current value in increments of 0.02 A
CAUTION: Never energize continuously for a long time.
scientia non olet · About LEMON Manuals