LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Transfer: TY20A >> Ecu Diagnosis >> AWD Control Unit >> Reference Value >> Physical Values

Physical Values

*: The values are changed by throttle opening and engine speed.

CAUTION: When using circuit tester to measure voltage for inspection, be sure not to extend forcibly any connector terminals.
VOLTAGE SPECIFICATION

Terminal No. (Wire color) Description Condition Value (Approx.)
+ - Signal name Input/Output
1 (LG) Ground AWD solenoid power supply Output Engine speed: At idle AWD LOCK indicator lamp: OFF 0 V
AWD LOCK indicator lamp: ON 0 V
Engine speed: 3,000 rpm or more constant AWD LOCK indicator lamp: OFF 2.5 V(1)
AWD LOCK indicator lamp: ON 8 V
2 (L) Ground AWD solenoid ground - Engine speed: At idle 0 V
Engine speed: 3,000 rpm or more constant 0 V
7 (R) Ground Ignition switch Input Ignition switch: ON Battery voltage
Ignition switch: OFF 0 V
8 (L) - CAN-H Input/Output - -
9 (G) Ground Power supply (AWD solenoid) Input Always Battery voltage
10 (B) Ground Ground - Always 0 V
11 (B) Ground Ground - Always 0 V
14 (Y) Ground AWD lock switch Output Ignition switch: ON Releasing AWD lock switch Battery voltage
AWD lock switch is hold pressed. 0 V
16 (P) - CAN-L Input/Output - -
(1) The values are changed by throttle opening and engine speed.
scientia non olet · About LEMON Manuals