LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Transfer: TY20A >> Disassembly And Assembly >> Drive Pinion >> Adjustment >> Companion Flange RUNOUT

Companion Flange RUNOUT

  1. Fit a dial indicator onto the companion flange face (inner side of the propeller shaft mounting bolt holes).
  2. Rotate the companion flange to check for runout.

    Limit 

    Companion flange runout : Refer to  "COMPANION FLANGE RUNOUT ".

  3. Fit a test indicator to the inner side of the companion flange (socket diameter).
  4. Rotate the companion flange to check for runout.
    Fig 1: Rotating Companion Flange
    G05892807Courtesy of NISSAN MOTOR CO., U.S.A.

    Limit 

    Companion flange runout : Refer to  "COMPANION FLANGE RUNOUT ".

  5. If the runout value is outside the repair limit, follow the procedure below to adjust.
    1. While changing the phase between companion flange and drive pinion gear by 90° at a time, check runout and determine which phase angle minimizes the runout.
    2. If the runout value is still outside of the limit after the phase has been changed, replace the companion flange.
    3. If the runout is out of the specification after replacement of companion flange, adjust the assembly status of the pinion bearings and drive pinion gear, or replace the pinion bearings.
scientia non olet · About LEMON Manuals