LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Rear Final Drive: R145 >> Disassembly And Assembly >> Electric Controlled Coupling >> Disassembly

Electric Controlled Coupling: Disassembly

  1. Remove connector bracket.
  2. Put matching mark on the thread edge of electric controlled coupling. The matching mark should be in line with the matching mark on companion flange.
    CAUTION: For matching mark, use paint. Never damage electric controlled coupling.
    NOTE: When replacing electric controlled coupling, matching mark is not necessary.
    Fig 1: Aligning Matching Mark Of Electric Controlled Coupling
    G04921349Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove companion flange lock nut, using a flange wrench (commercial service tool).
    Fig 2: Identifying Companion Flange Lock Nut With Flange Wrench
    G04921381Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove companion flange.
  5. Remove coupling cover.
  6. Remove front oil seal from coupling cover, using a suitable tool.
    CAUTION: Be careful not to damage coupling cover.
    Fig 3: Identifying Front Oil Seal From Coupling Cover
    G04921382Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove electric controlled coupling.
  8. Remove AWD solenoid harness.
  9. Remove center oil seal from gear carrier.
scientia non olet · About LEMON Manuals