LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> Murano LE >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Transfer Case, Rear Propeller Shaft & Rear Final Drive >> Rear Final Drive: R145 >> Disassembly And Assembly >> Drive Pinion >> Adjustment >> Drive Gear RUNOUT

Drive Gear RUNOUT

  1. Remove rear cover. Refer to "DISASSEMBLY ".
  2. Following the procedure below, install a dummy cover set [SST: KV381086S1 (-)] to gear carrier.
    1. Set dummy cover shims [SST: KV38108630 (-)] to the right and left side bearing adjusting shims.
    2. Temporarily tighten dummy cover [SST: KV38108610 (-)] to gear carrier.
    3. Position dummy cover spacers [SST: KY38108621 (-)] to dummy cover [SST: 38108610 (-)].
    4. Tighten rear cover mounting bolts to the specified torque. Refer to "EXPLODED VIEW ".
    5. Tighten dummy cover spacer mounting bolts evenly to the specified torque.

    : 5.9 N.m (0.6 kg-m, 52 in-lb) 

  3. Fit a dial indicator to the drive gear back face.
  4. Rotate the drive gear to measure runout.

    Limit 

    Drive gear back face runout : Refer to  "DRIVE GEAR RUNOUT ".

    • If the runout is outside of the repair limit, check drive gear assembly condition; foreign material may be caught between drive gear and differential case, or differential case or drive gear may be deformed, etc.
    CAUTION: Replace drive gear and drive pinion as a set.
    Fig 1: Measuring Drive Gear Runout With Dial Indicator
    G04921371Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals