Physical Values
PHYSICAL VALUES REFERENCE
| Terminal No. (Wire color) | Description | Condition | Value (Approx.) | |||
|---|---|---|---|---|---|---|
| + | - | Signal name | Input/Output | |||
| 1 (Y) | Ground | Battery power supply | Input | Ignition switch OFF | - | Battery voltage |
| 2 (O) | Ground | IGN signal | Input | Ignition switch ON | - | Battery voltage |
| 3 (B) | Ground | Ground | - | Ignition switch ON | - | 0 V |
| 5 (SB) | Ground | Illumination control signal | Output | Ignition switch ON |
|
|
|
||||||
| 8 (SB) | 10 (O) | Trip reset signal | Input | Ignition switch ON | When trip reset switch is pressed. | 0 V |
| Other than the above | 5 V | |||||
| 10 (O) | Ground | Meter control switch ground | - | Ignition switch ON | - | 0 V |
| 11 (L) | 1 (O) | Enter switch signal | Input | Ignition switch ON | When □ is pressed. | 0 V |
| Other than the above | 5 V | |||||
| 12 (R) | 10 (O) | Select switch signal | Input | Ignition switch ON | When • is pressed. | 0 V |
| Other than the above | 5 V | |||||
| 13 (Y) | 1 (O) | Illumination control switch signal (+) | Input | Ignition switch ON | When illumination controal switch (+) is pressed. | 0 V |
| Other than the above | 5 V | |||||
| 14 (GR) | 10 (O) | Illumination control switch signal (-) | Input | Ignition switch ON | When illumination control switch (-) is pressed. | 0 V |
| Other than the above | 5 V | |||||
| 15 (BR) | Ground | Air bag signal | Input | Ignition switch ON | Air bag warning lamp ON | 4 V |
| Air bag warning lamp OFF | 0 V | |||||
| 18 (L) | Ground | Ambient sensor signal | Input | Ignition switch ON | Changes depending to ambient temperature. | |
| 19 (P) | Ground | Ambient sensor power | Input | Ignition switch ON | - | 5 V |
| 20 (Y) | Ground | Ambient sensor ground | Input | Ignition switch ON | - | 0 V |
| 21 (L) | - | CAN-H | - | - | - | - |
| 22 (P) | - | CAN-L | - | - | - | - |
| 23 (B) | Ground | Ground | - | Ignition switch ON | - | 0 V |
| 24 (W) | Ground | Fuel level sensor signal ground | - | Ignition switch ON | - | 0 V |
| 25 (BR) | Ground | Alternator signal | Input | Ignition switch ON | Charge warning lamp ON | 2 V |
| Charge warning lamp OFF | 12 V | |||||
| 26 (G) | Ground | Parking brake switch signal | Input | Ignition switch ON | Parking brake ON | 0 V |
| Parking brake OFF | 5 V | |||||
| 27 (V) | Ground | Brake fluid level switch signal | Input | Ignition switch ON | Brake fluid level is normal | 12 V |
| Brake fluid level is less than LOW level | 0 V | |||||
| 29 (R) | Ground | Washer level switch signal | Input | Ignition switch ON | Washer level switch ON | 0 V |
| Washer level switch OFF | 5 V | |||||
| 30 (P) | Ground | Vehicle speed signal output (2-pulse) | Output | Ignition switch ON | Speedometer operated [When vehicle speed is approx. 40 km/h (25 MPH)] |
NOTE:
The maximum voltage varies depending on the specification (destination unit).
|
| 31 (V) | Ground | Vehicle speed signal output (8-pulse) | Output | Ignition switch ON | Speedometer operated [When vehicle speed is approx. 40 km/h (25 MPH)] |
NOTE:
The maximum voltage varies depending on the specification (destination unit).
|
| 32 (LG) | Ground | OD OFF switch signal | Input | Ignition switch ON | OD OFF switch pressed. | 0 V |
| OD OFF switch not pressed. | 12 V | |||||
| 34 (G) | Ground | Fuel level sensor signal | Input | Ignition switch ON | - | |
| 35 (SB) | Ground | Seat belt buckle switch signal (driver side) | Input | Ignition switch ON | When driver seat belt is fastened. | 12 V |
| When driver seat belt is unfastened. | 0 V | |||||
| 36 (R) | Ground | Seat belt buckle switch signal (passenger side) | Input | Ignition switch ON |
|
12 V |
|
0 V | |||||