Removal and Installation: Notes
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Never reuse CSC (Concentric Slave Cylinder) body and CSC tube. Because CSC slides back to the original position every time when removing transmission assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage. Refer to "REMOVAL AND INSTALLATION ".
- Never bring any grease to the clutch disc facing, pressure plate surface and flywheel surface.
- Never clean clutch disc using solvent.
If flywheel is removed, align dowel pin with the smallest hole of flywheel. Refer to "DISASSEMBLY AND ASSEMBLY ".