LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> 370Z Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Clutch) >> Removal And Installation >> Clutch Disc And Clutch Cover >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean clutch disc and main drive gear splines to remove grease and powder arisen from abrasion.
  2. Apply recommended grease to clutch disc and main drive gear splines.
    CAUTION: Be sure to apply grease to the points specified. Otherwise, noise, poor disengagement, or damage to the clutch may result. Excessive grease may cause slip or judder. And if it adheres to seal of CSC body, it cause clutch fluid leakage. Wipe out excess grease. Wipe out any grease oozing from the parts.
  3. Install clutch disc using a clutch aligner [Commercial service tool].
    CAUTION: If either clutch disc or clutch cover is needed to be replaced, replace them as a set.
  4. Install washers to clutch cover mounting bolts.
  5. Install clutch cover and then temporarily tighten clutch cover mounting bolts.
    Fig 1: Identifying Clutch Cover Mounting Bolts
    G04875579Courtesy of NISSAN MOTOR CO., U.S.A.
    CAUTION: If either clutch disc or clutch cover is needed to be replaced, replace them as a set.
  6. Tighten clutch cover mounting bolts to the specified torque evenly in two steps in the numerical order as shown in the figure.
  7. Install transmission assembly to the engine. Refer to "WITHOUT S-MODE : REMOVAL AND INSTALLATION " (Without S-MODE) or "WITH S-MODE : REMOVAL AND INSTALLATION " (With S-MODE).
scientia non olet · About LEMON Manuals