Clutch Disc

WARNING: This page is about a different variant/trim than selected.

Measure circumferential runout relative to clutch disc center spline. If it is outside the specification, replace clutch disc and clutch cover as a set.
Runout limit/diameter of the area to be measured : Refer to "CLUTCH DISC ".

Fig 1: Measuring Circumferential Runout
Courtesy of NISSAN MOTOR CO., U.S.A.
Measure backlash to clutch disc spline and main drive gear spline at the circumference of clutch disc. If it is outside the specification, replace clutch disc and clutch cover as a set.
Maximum allowable spline backlash (at outer edge of disc) : Refer to "CLUTCH DISC ".
Measure the depth "A" to clutch disc facing rivet heads using a calipers. If it exceeds the allowable wear limit, replace clutch disc and clutch cover as a set.
Facing wear limit (depth to the rivet head) "A" : Refer to "CLUTCH DISC ".

Fig 2: Measuring Depth "A" To Clutch Disc Facing Rivet Heads
Courtesy of NISSAN MOTOR CO., U.S.A.