LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> 370Z Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Clutch) >> On-Vehicle Repair >> Clutch Pedal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove kicking plate inner and dash side finisher LH. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove instrument lower panel LH. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect clutch pedal position switch and clutch interlock switch connectors and then remove clip of harness from clutch pedal.
  4. Remove snap pin and clevis pin from clevis.
  5. Remove clutch pedal position switch, clutch interlock switch, and pedal pad from clutch pedal.
  6. Remove stopper rubbers and pedal stopper rubber from clutch pedal using a suitable remover.
  7. Remove clutch pedal from the vehicle.
  8. Remove bushing from clutch pedal using a suitable drift [Commercial service tool].
scientia non olet · About LEMON Manuals