LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> 370Z Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Clutch) >> On-Vehicle Repair >> Clutch Master Cylinder >> Inspection and Adjustment >> Adjustment Before Installation

Adjustment Before Installation

WARNING: This page is about a different variant/trim than selected.
  1. Check the length "L" between clevis (1) and master cylinder (2).

    Length "L" between clevis and master cylinder :  Refer to "CLUTCH MASTER CYLINDER ".

  2. If measurement is outside the standard value, adjust the length "L" between clevis and master cylinder to the standard value.
  3. Tighten push rod lock nut (3) to the specified torque.
    Fig 1: Identifying Clevis, Push Rod Lock Nut And Master Cylinder
    G05973014Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals