Disassembly and Assembly: Assembly
WARNING: This page is about a different variant/trim than selected.
- Apply rubber lubricant to the internal surface of master cylinder, the sliding surface and piston cup of piston.
- Install return spring and piston to master cylinder.
- Apply silicone grease to push rod.
- Install push rod to master cylinder.
- Install stopper ring to master cylinder while holding push rod.CAUTION: Never reuse stopper ring.
- Install boot to master cylinder.
- Install push rod lock nut and clevis to push rod.
- Adjust the length "L" between clevis (1) and master cylinder (2) to the standard value.
Length "L" between clevis and master cylinder : Refer to "CLUTCH MASTER CYLINDER ".
Courtesy of NISSAN MOTOR CO., U.S.A.
NOTE: Clutch pedal height is controlled with position of clevis and master cylinder. - Tighten push rod lock nut (3) to the specified torque.