WITH S-MODE : Removal and Installation: Installation
WARNING: This page is about a different variant/trim than selected.
Note the following, and install in the reverse order of removal.
CAUTION:
- Secure transmission assembly to a suitable jack while installing it.
- The transmission assembly must not interfere with the three way catalyst (right bank) and three way catalyst (left bank).
- The transmission assembly must not interfere with the wire harnesses and clutch hose.
- The main drive gear must not interfere with the clutch cover.
- Never hold control lever housing to prevent the bushing of control lever housing from deformation when moving transmission assembly.
- Tighten transmission assembly mounting bolts to the specified torque. The figure is the view from the vehicle forward.TORQUE SPECIFICATION
Bolt symbol A B Insertion direction Transmission to engine Engine to transmission Number of bolts 8 4 Bolt length mm (in) 65 (2.56) 35 (1.38) Tightening torque N.m (kg-m, ft-lb) 75 (7.7, 55) 46.6 (4.8, 34) *: Tightening the bolt with air breather tube. - If flywheel is removed, align dowel pin with the smallest hole of flywheel. Refer to "DISASSEMBLY AND ASSEMBLY ".