Striking Rod

WARNING: This page is about a different variant/trim than selected.

Install low/high control lever to striking rod and then install retaining pin (<==) to low/high control lever using a pin punch [Commercial service tool].
CAUTION:
- Never reuse retaining pin.
- Be careful with the orientation of low/high control lever and striking rod.
- Assemble retaining pin from the direction shown by the arrow in the figure until it becomes flush with the end surface of low/high control lever.
  
  Fig 1: Locating Retaining Pin
  Courtesy of NISSAN MOTOR CO., U.S.A.
Install stopper ring to striking rod and then install retaining pin (<==) to stopper ring using a pin punch [Commercial service tool].

Fig 2: Locating Retaining Pin
Courtesy of NISSAN MOTOR CO., U.S.A.
CAUTION:
- Never reuse retaining pin.
- Be careful with the orientation of stopper ring and striking rod.
- Assemble retaining pin from the direction shown by the arrow in the figure until it becomes flush with the end surface of stopper ring.