Inspection After Disassembly

Gear

Check the gear for any damage, scaling, or uneven wear. Replace if necessary.

Fig 1: Checking Gear For Damage Area

Courtesy of NISSAN MOTOR CO., U.S.A.

Bulk Ring

Check the cam surface and contact surface of the bulk ring for damage and uneven wear. Replace if necessary.

Fig 2: Inspecting Cam Surface On Bulk Ring Or Contact Surface

Courtesy of NISSAN MOTOR CO., U.S.A.

Bulk Ring Clearance for Single Cone Synchronizer (5th)

Measure the clearance "A" when pressing the bulk ring (1) against the cone (B) of clutch gear by hands at 2 points or more on the opposite side using a feeler gauge (C), and then calculate the mean value. Replace if outside the limit value.

Clearance "A" :  Refer to "BULK RING CLEARANCE ".

Fig 3: Pressing Bulk Ring Against Cone Of Clutch Gear

Courtesy of NISSAN MOTOR CO., U.S.A.

Bearing

Check the bearing for damage and unsmooth rotation. Replace if necessary.

Fig 4: Checking Bearing For Damage And Unsmooth Rotation

Courtesy of NISSAN MOTOR CO., U.S.A.