LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2009 >> 370Z Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission (FS6R31A)) >> Disassembly And Assembly >> Main Drive Gear >> Disassembly

Main Drive Gear: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove 5th bulk ring, pilot bearing spacer, and main pilot bearing from main drive gear.
  2. Remove snap ring from main drive gear using snap ring pliers.
    Fig 1: Removing Snap Ring From Main Drive Gear
    G04875682Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove main drive gear bearing with the following procedure.
    1. Set a puller [Commercial service tool] to main drive gear bearing.
    2. Remove main drive gear bearing from main drive gear with a pressing machine.
      CAUTION: Never drop main drive gear.
      Fig 2: Removing Main Drive Gear Bearing
      G04875683Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals