LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Control System - DTCS P0447 To P0850 (Qr25DE)) >> DTC P0453 EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different variant/trim than selected.
  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Select "DATA MONITOR" mode with CONSULT-III.
  5. Make sure that "FUEL T/TMP SE" is more than 0°C (32°F).
  6. Wait at least 10 seconds.
  7. Check 1st trip DTC.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

scientia non olet · About LEMON Manuals