LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Control System - DTCS P0137 To P0445 (Qr25DE)) >> DTC P0340 CMP Sensor (Phase) >> Component Inspection >> Camshaft Position Sensor (Phase)

Camshaft Position Sensor (Phase)

WARNING: This page is about a different variant/trim than selected.
  1. Loosen the fixing bolt of the sensor.
  2. Disconnect camshaft position sensor (PHASE) harness connector.
  3. Remove the sensor.
  4. Visually check the sensor for chipping.
    Fig 1: Identifying Camshaft Position Sensor (Phase)
    G04926022Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Check resistance as shown in the figure.
    TERMINALS RESISTANCE CHART

    Terminal No. (Polarity) Resistance Ω [at 25°C (77°F)]
    1 (+) - 2 (-) Except 0 or ∞
    1 (+) - 3 (-)
    2 (+) - 3 (-)
  6. If NG, replace camshaft position sensor (PHASE).
    Fig 2: Checking Resistance
    G04925391Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals