LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Control System - DTCS P0137 To P0445 (Qr25DE)) >> DTC P0138, P0158 Ho2S2 >> DTC Confirmation Procedure >> Procedure For Malfunction A >> With CONSULT-III

With CONSULT-III

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
  2. Start engine and warm it up to the normal operating temperature.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Start engine and keep the engine speed between 3, 500 and 4, 000 RPM for at least 1 minute under no load.
  5. Let engine idle for 2 minutes.
  6. Check 1st trip DTC.
  7. If 1st trip DTC is detected, go to "PROCEDURE FOR MALFUNCTION A ".
scientia non olet · About LEMON Manuals