LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System - DTCS U1000 To P0153 (Qr25DE)) >> DTC P0131, P0151 A/F Sensor 1 >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different variant/trim than selected.
  1. Start engine and warm it up to normal operating temperature.
  2. Select "A/F SEN1 (B1)" or "A/F SEN 1 (B2)" in "DATA MONITOR" mode with CONSULT-III.
  3. Check "A/F SEN1 (B1)" or "A/F SEN 1 (B2)" indication.

    If the indication is constantly approx. 0V, go to "DIAGNOSTIC PROCEDURE ".

    If the indication is not constantly approx. 0V, go to next step.

  4. Turn ignition switch OFF, wait at least 10 seconds and then restart engine.
  5. Drive and accelerate vehicle to more than 40 km/h (25 MPH) within 20 seconds after restarting engine.
  6. Maintain the following conditions for about 20 consecutive seconds.
    ENG SPEED REFERENCE

    ENG SPEED 1, 000 - 3, 200 RPM
    VHCL SPEED SE More than 40 km/h (25 MPH)
    B/FUEL SCHDL 1.5 - 9.0 msec
    Shift lever Suitable position
    NOTE:
    • Keep the accelerator pedal as steady as possible during the cruising.
    • If this procedure is not completed within 1 minute after restarting engine at step  4, return to step  4.
  7. Check 1st trip DTC.
  8. If 1st trip DTC is displayed, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals