CONSULT-III Reference Value in Data Monitor Mode

WARNING: This page is about a different variant/trim than selected.

Specification data are reference values.

CONSULT-III REFERENCE VALUE CHART

MONITOR ITEM	CONDITION	SPECIFICATION
HO2S2 HTR (B1) HO2S2 HTR (B2)	Engine speed: Below 3, 600 RPM after the following conditions are met Engine: After warming up Keeping the engine speed between 3, 500 and 4, 000 RPM for 1 minute and at idle for 1 minute under no load	ON
Engine speed: Above 3, 600 RPM	OFF

MONITOR ITEM

CONDITION

SPECIFICATION

HO2S2 HTR (B1)
HO2S2 HTR (B2)

Engine: After warming up
Keeping the engine speed between 3, 500 and 4, 000 RPM for 1 minute and at idle for 1 minute under no load

OFF