Special Service Tools

WARNING: This page is about a different variant/trim than selected.

The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.

SPECIAL SERVICE TOOLS

Tool number (Kent-Moore No.) Tool name		Description
KV381054S0 (J-34286) Puller	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing mainshaft front bearing outer race
KV38100200 ( - ) Drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing mainshaft front bearing outer race Installing mainshaft rear bearing outer race Installing differential side bearing outer race (clutch housing side) a: 65 mm (2.56 in) dia. b: 49 mm (1.93 in) dia.
ST33220000 ( - ) Drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing input shaft oil seal a: 37 mm (1.46 in) dia. b: 31 mm (1.22 in) dia. c: 22 mm (0.87 in) dia.
ST33400001 (J-26082) Drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing differential side bearing outer race (transaxle case side) a: 60 mm (2.36 in) dia. b: 47 mm (1.85 in) dia.
KV38100300 (J-25523) Drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing differential side oil seal a: 54 mm (2.13 in) dia. b: 46 mm (1.81 in) dia. c: 32 mm (1.26 in) dia.
ST36720030 ( - ) Drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing input shaft rear bearing Installing mainshaft front bearing inner race a: 70 mm (2.76 in) dia. b: 40 mm (1.57 in) dia. c: 29 mm (1.14 in) dia.
ST33052000 ( - ) Drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing mainshaft rear bearing inner race Removing 6th main gear Removing 5th main gear Removing 4th main gear Removing 1st main gear Removing 1st-2nd synchronizer assembly Removing 2nd main gear Removing bushing Removing 3rd main gear Removing mainshaft front bearing inner race a: 22 mm (0.87 in) dia. b: 28 mm (1.10 in) dia.
KV32102700 ( - ) Drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing bushing Installing 2nd main gear Installing 3rd main gear Installing 4th main gear Installing 5th main gear Installing 6th main gear a: 54 mm (2.13 in) dia. b: 32 mm (1.26 in) dia.
ST30901000 (J-26010-01) Drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing mainshaft rear bearing inner race a: 79 mm (3.11 in) dia. b: 45 mm (1.77 in) dia. c: 35.2 mm (1.386 in) dia.
ST33061000 (J-8107-2) Drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing differential side bearing inner race (clutch housing side) a: 28.5 mm (1.122 in) dia. b: 38 mm (1.50 in) dia.