Disassembly and Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

Note the following. Assembly is in the reverse order of disassembly. Refer to "GEAR COMPONENTS ".

Press-fit the input shaft front bearing (1) onto the input shaft using a suitable tool (A).

Fig 1: Identifying Input Shaft Front Bearing Onto Input Shaft
Courtesy of NISSAN MOTOR CO., U.S.A.
Press-fit the input shaft rear bearing (1) onto the input shaft using a suitable tool (A), and Tool (B).
Tool number B: ST36720030 ( - )

CAUTION:

Do not reuse snap ring.
Make sure that snap ring is securely installed in the groove.

Fig 2: Identifying Input Shaft
Courtesy of NISSAN MOTOR CO., U.S.A.
Be careful with the orientation of 3rd-4th synchronizer hub.
A: 3rd input gear side

B: 4th input gear side

Fig 3: Identifying 4th Input Gear Side And 3rd Input Gear Side
Courtesy of NISSAN MOTOR CO., U.S.A.
Be careful with the orientation of 5th-6th synchronizer hub.
1. 5th input gear side
2. 6th input gear side
  
  Fig 4: Identifying 5th Input Gear Side And 6th Input Gear Side
  Courtesy of NISSAN MOTOR CO., U.S.A.